Quick-drying glue Model designed for bonding polystyrene.The adhesive works by dissolving the surface layer of the material in the bonded portions, and they are compressed, softened material combines parts. Do not apply too much grease glue. Just gently rubbed glued and after a moment file. With a little practice, you can apply a spot on one of the parts and applying a second left to dry slightly squeezing. With long parts, first you need to spread both edges, and after a while again. Then fold and press and allowed to dry. Glue evaporates quickly, however, dissolved material must harden. Often when folded squeezed a little out of place glued. You must then leave the joint to dry completely and then file off the excess with a file or sandpaper. This is not difficult, because when dry, what has been squeezed by the hardness of plastic and perfectly fills the gap smaller. It is also a method to avoid partial filling. . Similarly, in the case of soiling model glue: you have to allow it to dry without touching. On the surface it will trace which can easily cope lightly sanding with fine sandpaper, provided that it is not damaged excessively element touching fingers. Then you will need to use putty.Capacity: 30 ml