FEATURES

  High rate(10KHz) Switching (PWM) Pulse Width Modulation

  Dynamic Braking to ensure prompt prop folding

  BEC (2.0amps) provides power to receiver and servos.

  Overheat Protected

  Low Voltage Cut-off.

  Brake Mode

  Timing Advance

  Motor Rotation

  Safe Arming System protects user from startup accidents

  Built in Radio Fail Safe

  Micro Processor Controlled

  USB-LINKER for computer application

NOTE ：

        HV-Series signal lead - connect HV-Series unit long signal lead into the throttle channel on your receiver, the short one is for computer connect only. Connect your isolate power to receiver's battery port. Don't operate HV-Series by a servo tester, because it could happened that motor will do some short starts in reason of some incorrect “throttle impulses”. For this we strongly recommend to only using receivers from relevant and reliable manufactories.

        HV-Series Low Voltage Cutoff - The customer choice can be only used in computer interface software. Through this way, you can setting the cutoff voltage by yourself. The step is 0.1v up and down.

                                   Download ESC Instructions                  Download ESC CONFIG