The CC3D (OpenPilot) has dimensions of 46 x 39 x 15 mm and weighs only 14 g.

The powerful STM32 32-bit microcontroller is equipped with 128 kB flash memory, 20 kB RAM and a 3-axis high-performance accelerometer type MPU-3000. For configuration storage, the CC3D has a built-in 4 Mbit/s on-board EEPROM.

The tiny 36 x 36mm 4-layer PCB has a superior electrical noise reduction.

SPEKTRUM satellite receivers as well as Futaba S-BUS hardware are supported.

The innovative Flexi-port gives the flexibility to use either I2C and a single serial port or dual serial ports.

OpenPilot has tried to make your experience with the CC3D as easy and trouble-free as possible. Naturally for a high-end product, the hardware is complete.

There is nothing to solder. The included RC harness allows you to connect any standard PWM receiver.

All CC3D boards are tested before shipping and come with bootloader already flashed.

A mini-USB cable (not included) is used to load the latest firmware and configure everything for any unique airframe.

The OpenPilot project (www.openpilot.org) is trying to make open source much more user friendly.

All major operating systems are supported and install packages are provided.

The software is all free software under the GPLv3 license.