Description:
General sensor for Graupner HoTT receiver and models with electric motor.

Age recommended by manufacturer: 14 years and up

functions:

• Vario with altitude signals and 5 climb and 5 drop signal sounds, plus additional warning thresholds for min. altitude, max. altitude, climb and drop speeds in two stages
• Altitude display (- 500 ... + 3000 m) and storage of the min. and max. altitude.
• 2x temperature and voltage measurements with warning thresholds for min. and max. voltage and min. and max. temperature
• Single cell measurement 2 ... 14S with warning thresholds for min. voltage
• Voltage, current and capacity measurement with warning thresholds for min. and max. voltage, max. capacity and max. current
• Programmable current limiting
• Current measurement with shunt resistors 2x 0.2 mOhm (5 W) parallel = 0.1 mOhm
• Adjustable warning time: OFF, 5, 10, 15, 20, 25, 30 seconds, always
• Adjustable warning repetition time: Always, 1, 2, 3, 4, 5 min, once

Important Note when using the modules 33600, 33601, 33610, 33611 and 33620:
Do not carry out any programming work on the sensors while the model is flying, otherwise there is a real risk that your model will fly out of control while you are not concentrating on it!
If your model is fitted with two or more receivers, it is absolutely essential that you do not carry out programming work during a flight, as this can alter the settings in the receivers to which no telemetry equipment is connected; in the worst case this could result in the model crashing! For this reason always carry out programming on the ground, and check that only the receiver with connected sensor is powered on.

Connections and Technical data Vario:

• 2x temperature selectively 0 to 120°C or 200°C and voltage measurement up to 60 V DC
• 1x speed controller input, 1x speed controller output for single cell undervoltage correction
• 1x current and voltage and capacity measurement up to 150 A (short-term 1 sec 320 A) and up to 60 V DC
• 1x single cell monitoring for 2 - 14S lithium batteries (LiPo, LiIo, LiFe)
• 1x telemetry connection for receiver
• Altitude measurement: -500 m ... +3000 m
• Resolution: 0.1m
• Vario sensitivity: 0.5 m/3 s, 1 m/3 s, 0.5 m/s, 1 m/1 s, 3 m/s programmable by tone
• Average calculation: 4 - 20 measurements programmable per measurement value

Specification
Dimensions (LxWxH): 51 x 47 x 18 mm
Operating voltage : 3,6 ... 8,4 V

• Manual: conversion for rpm sensor
• Operating Manual
• PC update software
• HoTT Software and Updates V3
• HoTT Software and Updates V4