Small switch , Big action

switching module 10 A it is possible to switch a load directly via a

receiver output. The receiver output must be programmed for level

control (ON / OFF). (From receiver software version V7.XX, with mz-32

also possible with gyro receivers #33579 GR-18 with vario, #33583

GR-24PRO with Airplane-/Helisoftware >=2.04)

A switch (toggle switch) can be assigned to the switching channel (mc-16 to mc-28 or mx-12 to mx-20, mz-18 and mz-24)
For

the mz-32 and mc-32 (version 2019), digital switches can also be

programmed on the touch screen as encoders. Both ON / OFF and FLASHING

With

the jumper it is possible to differentiate between supplying the load

through the receiver power (jumper set) or external power supply.

(Jumper pulled) For external power supply via X3 / X4, the jumper MUST

be pulled, otherwise the receiver, the components connected to the

receiver and the switching module will be damaged!

The unit (motor,

LED, light bulb, etc.) is connected to X1 / X2. No cables are soldered

to the board, so there is the possibility for different cable sizes and

connector types.

You can attach the module with either

double-sided tape or cable ties in the model. When mounting, make sure

that the board does not bend and that the underside of the board does

not touch any other components (risk of short circuit).

The supplied

shrink tubing is pushed over the board after soldering the cables to

X1-X4 and shrunk with a hot air blower. Output cable lengths and

thicknesses can be used for X1-X4, depending on where the unit is

located.

• Operating voltage 4,0 - 8,4V from receiver
• Switch current max. 10 A
• Switch voltage max. 20 V
• Dimensions 23 x 11 x 5 mm
• Weight < 2g
• Required control channels: 1x control or digital switch