Water Setup for Husky 1800 - pre-order at your retailer

Ever thought about using an RC hydroplane? Here ist he perfect accessory for this!

The Graupner Husky 1800S Floaters SET has been specifically designed for the Graupner Husky 1800S. The components made of SOLIDPOR® hard foam, plastic parts and aluminum pipes are stable and at the same timevery light. Due to the low weight, the higher air resistance in flight is hardly noticeable.

After the Graupner Husky 1800S float set has been screwed together, the assembly on the airplane model is only the dismantling of the main gear, the screwing of the floats on the fuselage, the tensioning of the tensioning cords and the mounting of the rudder linkage on the rudder.

The tightening and tensioning of the floats takes approx. 15 min. This, however, has to be done only once. Afterwards, the complete set can be mounted and disassembled on the fuselage. The conversion takes about 5 min

Suitable for

Husky 1800S ARTF (No. 13410)

Husky 1800S (No. 13410.100)

Optional

There is the possibility to install separate servos in the floats, to direct the rudders individually for each float.

Features

Very easy

Scale optics

Quick and easy installation

No additional servo required

Optionally, additional servos can be installed

The set contains

Float couple

Aluminum support

Mounting material

Required accessories

Servo digital DES 47 8 BB MG 12 mm (No. 7917)

2x Extension cablel GOLD 500 mm (No. 3935.50)

Specification

Width [mm]: 470 mm

Height [mm]: 200 mm

Weight [g]: 380 g

Overall length [mm]: 840 mm

Material: Graupner SOLIDPOR® Rigid Foam

Field of application: Water Flights

Difficulty level: Advanced